100% Fortinet FCSS_NST_SE-7.6 Guaranteed Success With Testing Engine

Fortinet FCSS_NST_SE-7.6 Exam Syllabus Topics:

Reference: https://nseti-pdfs.s3.us-west-2.amazonaws.com/desc/Network_Security_Support_Engineer_7.6_Exam_Description.pdf

Fortinet FCSS_NST_SE-7.6 Exam Overview:

Fortinet FCSS - Network Security 7.6 Support Engineer Sample Questions:

Question #1
Refer to the exhibits.

An OSPF peer is advertising route 172.16.52.0/24. The local FortiGate is configured with an inbound distribution list that allows the 172.16.0.0/16 network to be injected into its routing table. However, the 1 '
2.16.52.0/24 subnet cannot be seen in the FIB.
Which two stops can the administrator of the local FortiGate take to ensure that the advertised 172.16. 52.0/24 subnet will be injected into the routing table? (Choose two.)

A. Modify the default prefix-list behavior from implicit deny to implicit allow.
B. Change the R- value lo 16.
C. Add another entry to the prefix list to specifically allow the 172.16.52.0/24 network.
D. Change the ge value to 17.

Question #2
Which three common FortiGate-to-collector-agent connectivity issues can you identify using the FSSO real- time debug? (Choose three.)

A. Mismatched pre-shared password.
B. Log is full on the collector agent.
C. Refused connection. Potential mismatch of TCP port.
D. Incompatible collector agent software version.
E. Inability to reach IP address of the collector agent.

Question #3
A VPN tunnel is up. To monitor traffic flow, the administrator enters the following CLI commands on an SSH session on FortiGate:
# diagnose debug enable
# diagnose sniffer packet any ' udp and port 500 ' 4
However, the sniffer does not show any output. Assuming default configuration values, what are two possible reasons there is no output? (Choose two answers)

A. The sniffer output will be ignored because running diagnose debug enable shows only application real- time debugs.
B. The filter should be modified to also capture packets for TCP port 443 or UDP port 4500 .
C. NAT Traversal is enabled.
D. The sniffer must be restricted to the remote peer IP address.

Question #4
Refer to the exhibit, which shows the modified output of the routing kernel.

Which statement is true?

A. The egress interface associated with static route 8.8.8.8/32 is administratively up.
B. The default static route through port2 is in the forwarding information base.
C. The BGP route to 10.0.4.0/24 is not in the forwarding information base.
D. The default static route through 10.200.1.254 is not in the forwarding information base.

Question #5
Which Iwo troubleshooting steps should you perform lf you encounter issues with intermittent web filter behavior? (Choose two.)

A. Check that the communication between FortiGate and FortiGuard is stable
B. Check that FortiGate is not entering conserve mode.
C. Check that the inspection mode configured for the web filter profile matches that of the firewall policy where it is applied.
D. Check that the correct port is mapped to HTTP in the Protocol Options

Solutions: